Waterworks work

Last week, we needed to get our pool ready for the scheduled installation of a new liner. The first step was to remove the winter pool cover. Ted estimates the cover weighs about 80 pounds, not counting the water it picks up as we drag it over the pool to remove it. I think his estimate might be low. I had already washed the driveway so we could spread the cover out to hose it off before we pack it away until late fall. Our neighbor, Will, saw us washing the pool cover and said, “Oh, no! If you guys are opening your pool, it’s going to snow next week!” Hahaha.

While the cover lay drying in the sun, we started draining the pool. With the pump pulling the water out through a two-inch hose, that took about 5 hours. While waiting for the pool to drain, I power washed the winter dirt from the pool deck and the patio, and hosed off the sidewalks and the front porch. Ted brought out a few more pieces of lawn furniture for the nicer weather, then mowed the lawn.

With a new liner coming, we wanted the pool steps and the upper edge around the pool to be sparkling white. It’s much easier to clean the edge by standing in the pool than to kneel on the pool deck, leaning over the water to scrub it. Since the pool was empty, Ted got to work.

If you’re a long-term reader, you might be thinking, “Didn’t they just put in a new liner a few years ago?” You’re right; liners should last at least 10 years. Look at the top edge of the liner in the photo above. It looks like there’s a dark border, but that’s not a border; that’s how much the liner faded in 3 years. When the pool guy saw that, he said it should have lasted much longer (say, 10 years), so he activated the warranty to save us a chunk of money on the new liner and on the installation labor. A closer look at the liner in the photo below clearly shows the fading. It also shows why Ted is scrubbing dirt off the top white edge.

The pool crew arrived bright and early the next morning. They cut around the bottom edge of the liner and removed the bottom piece, then released the sides, and carted it all away. There was some clean-up to be done before dropping the new liner. Hard objects and / or deep depressions under the vinyl liner can result in puncture holes, so a complete and detailed vacuuming and some touch-up fill work were needed.

Two hours after the crew arrived, they had the new liner dropped and they were making some final adjustments before working out all the wrinkles and installing the jets, the light, and the drain covers.

The guys started filling the pool before they left and told us to turn off the water when it reached the bottom step. The next morning, they came back to adjust any remaining stubborn wrinkles that had been pushed ahead of the water. After that, we were “go” to fill it all the way. With two hoses running, it took 16 hours to fill the pool to the top. One of the pool crew guys came back the next day to install the ladder and the railings, to turn on the pump, and to check the equipment to make sure everything was running well. We are now ready for the 2021 swim season.

Meanwhile . . .

Having a new hot tub means having one more thing to clean up in the spring and in the fall. We’ve been enjoying the hot tub for almost six months, so it’s time to freshen it up. That job turned out to be a lot more time-consuming than we’d expected.

The obvious first step was to drain the hot tub. It sounds easy and there really isn’t anything to do except connect a garden hose to the hot tub drain. BUT, first you have to bring the water temperature down from that lovely, relaxing 104 degrees. The owner’s manual suggested 24 hours, but the overnight temperature dropped to the low 40s, so cooling the water wasn’t a problem–we just took the cover off and let the night air do its thing. The water was more than cool enough by morning, so while the pool was draining, we connected a garden hose to drain the hot tub. Draining it took a surprising 5 hours–the same amount of time it took to empty the pool, which has about 34 times more water than the hot tub. We did not see that coming! Talk about a setback in your schedule! The pool’s two big drains, its pump, and its two-inch drainage hose work a lot faster than a 5/8″ garden hose counting on gravity to do the work.

When the hot tub was (finally) drained, I started cleaning it while Ted cleaned up the pool. It sounds amazing when the literature and the salesman tell you that your hot tub has 6 gazillion jets. “Ooh, aah,” you say. “Is that the most we can get?” It’s a different story when you have to remove every jet to clean it. My sore fingertips felt like I unscrewed and pulled out about 6 gazillion jets, but I reasoned there probably weren’t more than 120. Hah! When I finished, I counted them and came up with only 62 jets–half of what my fingers “reasonably” felt like I had removed.

The jets had to be soaked in a vinegar/water mixture for 3 hours to remove any built-up residue in them. The two extra large jets that provide an awesome foot massage didn’t fit well in our pail and dishpan with the other jets, so we put them in the pail after the first load of jets was finished soaking. As a result, the total soak time was 6 hours. We opted for the extended time because we’d already used 1.5 gallons of vinegar and we didn’t feel like making another trip to the grocery store for more vinegar to do only two more jets.

While the jets soaked, I scrubbed. The pool store sold us some awesome non-sudsing cleaner for the tub surface. I just sprayed it on and wiped it off, and it left the surface as smooth and clean as if it had never been used. No hard scrubbing needed. I bet it would work great for cleaning the bathroom.

After removing and washing the headrests, I moved on to the exterior of the hot tub and wiped down the sides to get rid of the winter grit. The final cleaning task was to wash the cover and apply a coat of protectant to help prevent premature fading and weathering. That was pretty simple too–just time-consuming. Aren’t you impressed that Ted’s pictures show me smiling while I work? I feel like a TV ad. The truth is, the job wasn’t awful, but I’m good with only needing to do all of this twice a year, and we both feel that way about the pool too.

At last, I could put the garden hose inside the hot tub to fill it. It filled in about 45 minutes, but it wasn’t warm enough by evening to relax our sore muscles from all the work of cleaning the pool and the hot tub.

After spending two days getting our waterworks cleaned up for the summer season, there’s a change in the weather forecast. After a high temperature of 75 degrees today, tomorrow’s forecast includes falling temperatures, rain possibly mixed with up to one inch of snow, and an overnight low in the mid-20s. More of the same is predicted for the following day and night, except the temperatures might be a few degrees warmer. Will was right. It’s been a week since we opened the pool and we’ll probably see some snow tomorrow.